Consistency and reliability are usually considered to be in tension because of the CAP theorem. And when working on a distributed system, it’s normal to get focused on trying to improve service reliability. Sometimes, we can take shortcuts that will increase reliability at the expense of returning stale results more often.
But consistency shouldn’t be seen as opposing reliability. In fact, I think they’re very similar. If your service has 6 9s of reliability (number of successful requests / number of total requests) but only 3 9s of consistency (number of consistent requests / number of successful requests), do you really have 6 9s of reliability? After all, you’re getting some of those extra 9s just by returning a wrong answer.
With my definition of consistency (how many successful requests are consistent), it’s arguably better to prioritize adding more 9s of consistency than reliability.
I was just reading my colleague Lu Pan’s blog post about C++ exceptions when I saw this quote:
The reason why it uses xor eax eax to set a register to 0 is for efficiency reason. It produces shorter opcode and enables the processor to perform register renaming.Lu Pan
C++ exception (1) — zero-cost exception handling
I found this rather baffling for a few reasons. First of all, isn’t zeroing out a register a common enough operation that it should be optimized?
Further, why would using
xor better for register renaming? Intuitively it seems like it might even be worse since the two operand registers and the result register are all the same.
The obvious way to zero a register is with
mov. This instruction takes 7 bytes:
0: 48 c7 c0 00 00 00 00 mov rax,0x0
It actually includes a full 4 byte immediate value. That wastes quite a bit of space in the instruction.
xor, the same instruction takes only 3 bytes.
0: 48 31 c0 xor rax,rax
It pretty much looks like the
mov instruction but without the immediate (and a different opcode of course).
It turns out that Intel has a few dependency breaking idioms in their optimization manual:
Assembly/Compiler Coding Rule 36. (M impact, ML generality) Use dependency-breaking-idiom instructions to set a register to 0, or to break a false dependence chain resulting from re-use of registers.Section 220.127.116.11 Clearing Registers and Dependency Breaking Idioms
Intel® 64 and IA-32 Architectures Optimization Reference Manual
So actually while it seems strange that
xor would be better for register renaming despite referencing the register twice, this particular instruction is explicitly handled by Intel. They themselves recommend it as the best way to zero a register. In fact, the CPU will explicitly skip as many steps as possible on this instruction in order to efficiently zero the register.